Forta de strangere suruburi cuzineti axa cu came

27. Fit piston 3
• Proceed as for piston 2


28. Raise vehicle

29. Install con-rod bearing covers 2 and 3 (1)
• Coat con-rod bearing journals with engine oil

• Tighten 4x bolt 35 Nm + 45° + 15°
– Replace bolts





30. Turn crankshaft on torsional vibration damper 180° in direction of engine rotation

31. Lower vehicle

32. Set piston ring joint piston 1
• Proceed as for piston 2


33. Fit piston 1
• Proceed as for piston 2


34. Set piston ring joint piston 4
• Proceed as for piston 2


35. Fit piston 4
• Proceed as for piston 2


36. Raise vehicle

37. Install con-rod bearing covers 1 and 4 (1)
Important: Note the markings

• Coat con-rod bearing journals with engine oil

• Tighten 4x bolt 35 Nm + 45° + 15°
– Replace bolts




Deci musai suruburi noi pe original, curatat filet cu spray de frane, uleiul nu are ce cauta acolo. Daca nu faci asa va troncani dupa care ies bielele prin bloc.

Posibil sa trebuiasca pasta de blocare filet pentru suruburi.

Vectra C - Z18XER 2006-2008
http://postimg.org/image/6u8cfk9id/full
http://postimg.org/image/8uzfuwojn/full - spor la tradus.
Sa ne scri si noua valorile de strangere.

Poate te ajuta. - ori nu apar toate datele ori nu inteleg eu prea bine.
http://workshop-manuals.com...check_and_adjust/ - Astra H
Poate te mai indruma colegi (daca este bine sau nu.)
De la punctul 46. in jos.

Ca comparatie
http://workshop-manuals.com...move_and_install/

Multumesc T.ion era 8Nm din ce am inteles eu in manualul de la astra